First, tire inspection
The tire pressure should be checked at room temperature every month. If it is lower than the normal standard, the tire pressure should be replenished in time. The air pressure cannot be too high or too low, otherwise it will affect driving safety. Check the tires for cracks and replace them promptly if there is a safety hazard. When selecting tires, they should be of the same model.
Second, battery maintenance and inspection
Check whether the battery is firmly fixed. The electrolyte should be between the upper and lower limits. When approaching the offline line, add electrolyte or distilled water to the high line in time. Keep the positive and negative cables of the battery in good contact, and keep the battery clean and dry. For vehicles that have been left for a long time, remove the positive and negative cables of the battery, reconnect them every half a month and start the engine for about 20 minutes. If the battery is obviously insufficient, charge it in time.
Third, check the clutch master cylinder fluid level
If the clutch fluid level is between the high and low fluid levels, it means it is normal. If it is lower than the standard line, the master cylinder or slave cylinder cup may be damaged. When the engine is running, it will be difficult or impossible to shift into gear. Please go to the nearest service station for repair immediately.
Fourth, check the brake fluid level
If the brake is also between high and low, it means normal. If the brake fluid is close to the lower limit or lower than the lower limit, it means there may be leakage in the system or the brake shoes are too worn, and you should go to the service station for repair in time. When adding brake fluid, pay attention to adding the same type of brake fluid to prevent damage to the leather cup, and pay attention to protecting the paint to prevent corrosion of the paint surface.
Fifth, engine coolant level inspection
Never open the radiator cap when the engine is hot, otherwise you may be burned by splashed coolant or high-temperature steam. After the engine cools down, check that the coolant level should be between the full level and the low level. Otherwise, distilled water, purified water, or refrigerant should be added. The liquid level after adding water should not exceed the full level. If you find that the coolant decreases rapidly in a short period of time, you should check the cooling system for leaks or go to a maintenance station for inspection.
